HP系列激打进入维修服务方式(2)

 
HP系列激打进入维修服务方式(2)

( HP 1100, 1200 HP 2100 HP 2200 HP 5P & 6P)

HP Laserjets - Cold Reset Instructions
Cold resetting a printer resets the printer to factory defaults. Any settings you make at the printers control panel will be reset to factory defaults, including the IP address if you have a JetDirect card installed. Remove the JetDirect card while you cold reset the printer if you don't want to erase the JetDirect card's settings.
You can also reset the NVRAM. Resetting the NVRAM will clear the page count and reset the service mode settings to factory defaults. On printers with a display panel you need to enter service mode to manually change the information stored in NVRAM. On printers that don't have a display panel, such as a 5P, 6P, 2100, 2200 there is a different procedure outlined below. 

 
Printers with a display panel. (e.g. 4000, 4100, 5si, 8000, etc.)
    Cold resetting the printer is simply a matter of turning the power off, holding down the GO or Online button while turning the printer on.
Resetting NVRAM settings must be done manually through service mode. See entering service mode.

Printers without a display panel.
 
    HP 1100, 1200 - While the printer is on, press and hold the Go button for 5 seconds. This will reset the printer.
To reset the NVRAM. Turn the printer off. Press and hold the Go button for 20 seconds while powering on the printer.

HP 2100 - To perform a cold reset, turn the printer power off, then press and hold the JOB CANCEL button. Turn the printer power back on and after all the LEDs come on release the JOB CANCEL button. A cold reset changes most system parameters in NVRAM to the factory defaults. The JOB CANCEL button must be released within 20 seconds after all of the LEDs come on; otherwise, an NVRAM initialization is performed instead of a cold reset.

HP 2200 –
Cold reset: 1. Turn the printer power off.2. Press and hold GO.3. Turn the printer power back on and continue to hold GO until the Attention light turns on.4. Release GO.5. The device lights will begin cycling from front to rear. The cold-reset process will run until completion and the device will go to the ready state.NVRAM
    Reset:1. Turn the printer power off.2. Press and hold GO.3. Turn the printer power back on and continue to hold GO until the Attention, Ready, and Go lights turn on.4. Release GO.5. The device lights will begin cycling from font to rear. The NVRAM initialization will run until completion and the device will go to the ready state.

HP 5P & 6P
Cold reset: turn the power off and hold the reset button (button closest to the back of the printer) for LESS than 20 seconds while turning the printer on.Reset the NVRAM: turn the power off and hold the reset button for MORE than 20 seconds while turning the printer on.